Welcome to GL Innovations
I have a GL-AR150. Can I just run regular OpenWrt on it? I don’t want the GL-iNet services or web interface.
Yes. You can install the firmware from OpenWrt trunk. We also have a clean OpenWrt-CC firmware for AR150 with Luci: http://www.gl-inet.com/firmware/ar150/clean/
Hi, can GL AR150 support usb internet dongle? I’d like to use mobile network to connect to internet.
Yes. It can. Please check if your model is supported by OpenWrt.
Thanks for your prompt reply. Are you talking about ROOter?
can you confirm that this product is fully supported by the original image (trunk?) of OpenWRT ?
Thanks a lot.
Yes. I can confirm. It is in trunk!
Hello! I have a plc with 24vdc out. Can i use this 24vdc in any way to power this router? With the poe board? Or does that board only deliver power OUT from the router?
Unfortunately I don’t think you can use this power. Even with PoE, you need to use an active 802.3af PoE switch, which is 48V.
I like to do the following
1. Connect external USB wifi adapter on USB port and use the same to connect to my home wifi AP.
2. Create a local TOR AP and connect devices to it.
Yes. It is possible. Just need to check the firewall so Tor is not routed to nowhere because one extra WLAN.
Hi I just bought this product, I will like to know if I can program the smart router with a usb mobile internet and a common internet by cable . Does the product detect the best signal and uses the one that is working better?
There are two methods to use multiwan, one is https://wiki.openwrt.org/doc/howto/mwan3 and another is https://wiki.openwrt.org/doc/uci/multiwan
There are load balancing in these two methods. But I don’t know if the router can detect which one is better.
Which of these can be configured as a Repeater?
all mini routers can be configured as repeater.
How do I make it so that it connects to a VPN like IPVanish or HMA automatically?
Please read the docs here: http://www.gl-inet.com/docs/wiki/#!openwrt/openvpn.md
ooops , just tried to flash with open WRT and now the router is doing nothing , how do i start again !
Check this: http://www.gl-inet.com/docs/wiki/#!mini/firmware.md
use uboot webUI.
Please enter an answer in digits: